For DJI Mini 3 Pro RCSTQ Drone Accessories

1. The design of the translucent protective cover makes it easy to observe the protection status of the gimbal at any time
2. Not afraid of bending, spring back in seconds, the protective cover of the gimbal is made of PVC material with toughness, which can be bent to a certain extent and is not easy to deform
3. Four obstacle avoidance protection gimbal, lens, sensor, etc., integrated protection design, anti-knock, anti-scratch, anti-dust
4. Filter storage protection, the protective cover buckle does not affect the storage of various types of filters, and the filter can be removed
5. Snap-on design, one step in place
6. Effective protection Portable storage, all-round effective protection of the tip of the propeller, preventing the intricateness of the propeller blade, easy to store, not easy to bend
7. The product is molded with precision molds, combined with the fuselage design to effectively protect the front and rear propellers. At the same time, it is equipped with the gimbal camera protection cover for double protection to prevent the gimbal from being scratched and the propellers from being bent
8. Applicable models: suitable for DJI Mini 3 Pro
9. Material: PVC
10. Note: The product does not contain UAV Others
11. Dimensions: Lens cover: 7×6.6×5.5cm
12. Net weight: lens cap: 10.8g, propeller: 10.2g
13. Gross weight: lens cap: 52.7g, propeller: 40.4g

Propeller installation steps:
1. Align the front propellers first, then snap the propellers into the drone, press on the air vent of the fuselage, and the installation is complete when you hear the sound of “Tata”
2. Align the rear blades, then snap the blades into the drone, press the bottom notch, and the installation is complete when you hear the sound of the tower
3. On the basis of the protection of the propeller, install the gimbal camera protection cover, and now snap its top into the groove
4. Then snap the protective cover of the gimbal camera into the bottom of the fuselage, and the installation is complete

Steps to disassemble the propeller:
1. Pull the left and right sides of the oar restraint outward, and you can disassemble when you hear the sound of tata
2. Push down the paddle restrainer in the bottom notch to remove it
3. Take out the buckle at the bottom of the protective cover of the gimbal and camera upwards, and then it can be disassembled